A Note on “Surface Roughness Prediction Model in Machining of Carbon Steel by PVD Coated Cutting Tools”
- 1 Department of Engineering, University of the South Pacific, PO Box 1168, Suva, Fiji
Abstract
An article published in this journal by Sahin and Motorcu[1] developed a surface roughness model based on the response surface method, multiplicative-logarithmically linearized approach for determination of the cutting parameters in turning of AISI 1040 carbon steel. Their published results for the surface roughness show that it appears Sahin and Motorcu[1] have obtained wrong constants (C, m, n, p), thereby resulting in incorrect solutions for the surface roughness prediction model. This note works through the solutions to show how Sahin and Motorcu[1] incorrectly handled the published prediction model constants to their solution. The established predictive model shows that the surface roughness increases with the increase of feed rate but decreases with cutting speed and depth of cut.
DOI: https://doi.org/10.3844/ajassp.2005.1109.1112
Copyright: © 2005 Godfrey C. Onwubolu. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
- 3,616 Views
- 2,672 Downloads
- 15 Citations
Download
Keywords
- Turning operations
- surface roughness
- response surface method