AJAS Cover
Frequency: Continuous
ISSN: 1546-9239 (Print)
ISSN: 1554-3641 (Online)
Research Article Open Access

Microstructural Study of Al-Si-Mg Alloy Reinforced with Stainless Steel Wires Composite via Casting Technique

Mazlee Mohd. Noor, Shamsul Baharin Jamaludin and Kamarudin Hussin

Abstract

The microstructural study of Al-Si-Mg alloy reinforced with stainless steel wires (Al-Si-Mg/SSw) has been investigated and focused on the both microstructures in the matrix and near to the interface and also the wetting condition at the interface. The wettability of solid metals by liquid metals is very important in determining the needed properties of the composite systems. In this study, the wetting conditions have been characterized using optical microscopy and scanning electron microscopy. Good wetting, incomplete wetting and very poor wetting associated with large voids are seen at the Al-Si-Mg/SSw interfaces. Heavily concentrated of needle shaped eutectic Si particles are found near to the single stainless steel wire as compared to double stainless steel wires.

American Journal of Applied Sciences
Volume 5 No. 6, 2008, 721-725

DOI: https://doi.org/10.3844/ajassp.2008.721.725

Submitted On: 24 September 2007 Published On: 30 June 2008

How to Cite: Noor, M. M., Jamaludin, S. B. & Hussin, K. (2008). Microstructural Study of Al-Si-Mg Alloy Reinforced with Stainless Steel Wires Composite via Casting Technique . American Journal of Applied Sciences, 5(6), 721-725. https://doi.org/10.3844/ajassp.2008.721.725

Open AccessCopyright: © 2008 Mazlee Mohd. Noor, Shamsul Baharin Jamaludin and Kamarudin Hussin. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

  • 3,291 Views
  • 2,689 Downloads
  • 2 Citations

Download

Keywords

  • Interface
  • wetting conditions
  • needle shaped eutectic Si particles